Specifications

24 Part Number STH12 9/10
down through the counter top, to connect to the
conduit. It will also be necessary to fully insulate this
new added section before passing through the counter
top, or before hooking to main conduit.
CARB WATER LINES
• Unit has two carb water lines, one for each flex
manifold.
• Use 2 @ 1/2" x 1/2" elbow and 6-12" of 1/2"
conduit tubing to make connection bend from unit
down through hole in counter top, to mate with
conduit.
• Conduit with only two circulating carb water lines.
• Use two @ 1/2" barb U-bend adapters (invert one)
to connect the two carb circulating lines from
conduit to the two carb water lines from the unit.
Use short 1/2" conduit line to connect the two
U-bends as shown (item #8).
• Conduit with four, two sets of recirculating carb
water lines.
• Use two @ 1/2" barb U-bend adapters, to connect
each set of circulating conduit lines to each carb
water line from unit as shown (8).
PLAIN WATER LINES
• Unit has two plain water lines, one for each flex
manifold.
• Use two @ 3/8" x 1/2" elbows and 6-12" of 1/2"
conduit tubing to make connection bend from unit
down through hole in counter top, to mate with
conduit.
• Conduit with only one plain water line.
• Use one @ 1/2" U-bend adapter, to connect the
two plain water lines to one plain water line from
conduit (item #3).
• Conduit has two plain water lines.
• Use two @ 1/2" straight adapters to connect each
plain water line from unit to each plain water line
from conduit as shown (3).