Instructions / Assembly

Part Number: 8014623 Rev01 2/17 5

General

These instructions are provided to assist the qualified

installer. Check your local Yellow Pages for the name of the

nearest Manitowoc distributor, or call Manitowoc Ice for

information.

The ArcticPure® water filtration systems are designed to

reduce coarse and fine particulate matter from the incoming

potable water supply. Chlorine will be reduced in the

water so as not to adversely affect the ice produced or the

equipment components. Scale inhibitor is automatically

fed into the water to inhibit the formation of scale on

water solenoids and evaporator plates. The NSF seal on

these products is recognized worldwide as a sign that the

product to which it is affixed complies with the public health

requirements.

• DO NOT install on line pressure above 125 psi (862 kPa).

• DO NOT install on hot water line. Maximum temperature

allowed is 100°F (38°C).

• DO NOT install in direct sunlight.

• DO NOT reverse connections. The system must be

installed with the inlet and outlet as labeled.

• DO NOT install ArcticPure® filter systems in locations

where they can be damaged by other free-standing

equipment.

• PROTECT from freezing.

• INSTALLATION must comply with existing state or local

plumbing codes.

This piece of equipment is made in America and has

American sizes on hardware. All metric conversions are

approximate and vary in size.

Safety

Always follow these safety precautions when installing and

operating the water filter system.

Warning

DO NOT use with water that is microbiologically unsafe or

of unknown quality without adequate disinfection before

or after the system.

Notice

DO NOT use a torch or other high temperature sources

near filter or cartridge.

Section 2

Installation