Instructions / Assembly

10 Part Number: 8014623 Rev01 2/17
Installation Section 2
10. Inspect the cartridge and o-rings for damage. See
Recommended Replacement Parts List if replacement is
required.
,
Caution
DO NOT use petroleum jelly.
11. Lubricate o-rings with food grade lubricant.
12. With the product label facing to the left, insert the
cartridge into the filter head. Rotate 1/4 turn to the right
to secure. Product label will face forward.
Installation Checklist

Have the min.-max. water temperature and pressure
been checked? (Refer to “General”)

Has the filter system been installed away from heavy
traffic areas?

Is the system installed securely to the mounting surface?

Has the water supply line been checked for suitability?
(Refer to “Water Service”)

Have the water supply lines been securely installed into
the inlet/outlet ports? (Refer to “Installation - AR-10000/
AR-20000 & AR-40000”)
Start-Up Procedure
1. Turn on the incoming water supply.
2. Check for leaks. If the connections are leaking, refer to
the Troubleshooting section of this manual to reinstall.
NOTE: System should be flushed for 2 minutes to remove
trapped air and carbon fines (5 minutes for AR-Pre).
To set the pressure gauge:
• Rotate the red follower needle clockwise until it contacts
the black pressure needle on the low side.
• The red follower needle will now record the lowest water
pressure when the filter system is in use.
NOTE: The filter pressure will decrease as the cartridge life
decreases.
Changing Cartridges
ArcticPure® cartridges will need to be changed for one or
more of the following reasons:
• The filter has trapped water-borne sediment and the
water flow has stopped or water pressure through the
filter has dropped below 20 psi (138 kPa).
• The maximum life of the carbon filter has been reached
and the filter will no longer reduce chlorine to acceptable
levels.
• The scale inhibitor has been completely dissolved and
hard scale build-up may accelerate.
It is recommended that ArcticPure® filter cartridges be
changed out:
• Every 6 months or when water pressure through the
system drops below 20 psi (138 kPa), whichever occurs
first.
To change the filter:
1. Rotate the cartridge 1/4 turn to the left. The cartridge
should easily release. Dispose of used cartridge.
Important
ArcticPure® systems are equipped with internal shut-off
valves. It is not necessary to shut off the incoming water
supply during cartridge changeout.
2. Remove the protective cap from the cartridge.
3. Inspect the cartridge and o-rings for damage. See
Replacement Parts list if replacement is required.
4. Lubricate o-rings with food grade lubricant.
,
Caution
DO NOT use petroleum jelly.
5. With the product label facing to the left, insert the
cartridge into the filter head. Rotate 1/4 turn to the right
to secure. Product label will face forward.