Specifications

94 Part Number STH14 9/10
PURGE/SANITIZE
Purge/Sanitize mode allows the user to purge air from
the syrup lines during initial start-up. The second
function of this mode is to energize the valves to move
sanitizer through all syrup lines automatically.
Enter the Purge/Sanitize Mode by press the program
button until “P – S” is displayed.
Pressing flavor button 1 (far left button) will activate a
sequenced four second dispense that starts with flavor
1 then to flavor 2 etc. The valves will continue to cycle
for 15 minutes or until the program button is pressed
once.
DISPENSING MODES
Normal Dispense
With power applied to the control board, it will
automatically start in dispense mode after a five
second delay. The LED display will count down from
four to zero and then show “- - - -” while in dispense
mode. Simply pressing the desired flavor on the
touchpad dispenses Flavor Magic.
Flavor Counter
The flavor counter tracks the number of flavor shots
dispensed per flavor. To access Flavor Counter Mode,
press the program button on the control board once for
at least three seconds. The LED display will show
“C n t”. In the count mode the Flavor Magic module will
not dispense. Check the number of dispenses for any
flavor by pressing the corresponding touchpad button.
To check another flavor press the program button once
and then the corresponding flavor button on the
touchpad. To return to dispense mode press the
program button until the LED display shows “- - - -”.
STH14.book Page 94 Thursday, September 23, 2010 3:35 PM