Service manual

Section 9 Replacement Procedures
9-15
Vinyl Breaker Strips (door jambs)
WARNING
Disconnect the electric power to the freezer before
proceeding with the following steps.
1. Remove the flat vinyl breakers by gently prying
off with a flat-blade screwdriver. (Figure 9.40)
WARNING
Door heater wires lie directly behind the front edge
of the flat breaker strips. Take care not to damage
the wires.
2. Remove the corner blocks as necessary by
slipping the male tab from the flat breaker.
3. Replace the breakers by starting each end into
the corner blocks and snapping into place.
4. Gently tap the breaker into place if necessary,
using a rubber mallet. (Figure 9.41)
Figure 9.40
Figure 9.41