Service manual

Section 9 Replacement Procedures
9-9
9. Carefully align the module with the rectangle
cutout in the hatch cover. Press the module
firmly into place. (Figure 9.25)
10. Plug the probe wire terminal onto the back of
the display module, making sure that the plug
lines up with the pins on the module
(Figure 9.26)
11. Reconnect the (2) yellow wires from the
transformer with the gray leads on the probe.
12. Reinstall the hatch cover and secure any excess
wire with a wire tie.
13. Check operation and return to normal service.
Figure 9.25
Figure 9.26