Service manual

Section 9 Replacement Procedures
9-7
5. Replace drain pan heater and reconnect wiring.
6. Reposition evaporator coil and secure with
mounting screws.
7. Reposition the evaporator housing cover and
lock down latches.
8. Attach front louvered hatch cove, making sure
that the thermometer connections are fully
engaged.
9. Return to normal use.
Heater Element
Heated Holding Cabinets
1. Turn off the main power to the cabinet.
2. Remove the right side blower panel by
removing the (13) screws.
NOTE: Blower motor wiring may be disconnected
to allow easier blower panel removal.
3. Disconnect the wiring leads to the element by
loosening the nuts with a small wrench.
4. Replace the heater element.
5. Reverse steps 1-3 to re-install the wiring and
blower panel.
Figure 9.22