Service manual

Section 9 Replacement Procedures
9-5
Temperature Control
Refrigerators & Freezers
1. Remove the front louvered hatch cover by
lifting straight up and pulling straight out.
2. Lay the hatch cover on top of the freezer
evaporator housing.
IMPORTANT
Do not disconnect the wires to the digital
thermometer display.
3. Remove the (6) screws from the
thermostat/wiring box front (Figure 9.16).
4. Remove the (2) mounting screws and the control
knob from the face of the control.
5. Remove the lid from the evaporator housing by
unlocking the (4) hold-down latches
(Figure 9.17).
6. Remove the temperature control sensor from the
aluminum sleeve by pulling out slowly
(Figure 9.18). Remove the sensor from the
evaporator housing.
7. Replace the temperature control and install
sensor.
8. Reset the temperature to setting #4 to #5 on
refrigerators and #5 to #6 on freezers.
9. Monitor temperature for final control
adjustments.
Figure 9.16
Figure 9.17
Figure 9.18