Service manual

Replacement Procedures Section 9
9-4
Evaporator Fan Motor
2 & 3 Section Refrigerators and Freezers
1. Remove the evaporator-housing lid, located on
the cabinet top, exposing the evaporator fan
motor (Figure 9.13).
2. Remove the wiring box cover. Locate and
disconnect the fan motor wires (Figure 9.14).
3. Remove the fan bracket mounting screws.
Disconnect the wiring terminals from the motor.
Remove the defective motor and replace with
the new motor. Replace screws (Figure 9.15).
4. Reconnect motor wires in wiring box. Check to
make sure that wire access hole through the
evaporator box is properly sealed and reseal if
necessary.
5. Replace wiring box cover.
6. Replace the evaporator-housing lid.
7. Reconnect power and return to normal use.
Figure 9.14
Figure 9.13
Figure 9.15