Service manual

Section 9 Replacement Procedures
9-3
6. When the coil has been moved, remove the
evaporator drain pan by removing (4) mounting
screws.
7. Remove the bracket mounting screws and
replace bracket-motor assembly.
8. Reverse Steps 1-5 to complete motor
installation.
9. Reconnect power and return to normal use.
Light Switch
1. Remove the door by lifting straight up
(Figure 9.10). Carefully set the door aside.
2. Pry off the TOP hinge cover on the cabinet
hinge flange with a flat blade screwdriver or flat
scraper (Figure 9.11).
3. Remove the (3) hinge mounting screws
and carefully pull the hinge flange from
the cabinet front.
4. Slide the light switch and switch retainer from
the hinge. Unplug the switch (Figure 9.12).
5. Install the new switch into the hinge and replace
the door hinge onto the cabinet front. Install the
(3) mounting screws. Snug the screws but DO
NOT tighten fully.
6. Re-hang the door onto the hinges.
7. Make sure that the door is hanging plumb and
that the door operates properly.
8. Tighten the screws and replace the hinge cover.
Figure 9.9
Figure 9.10
Figure 9.11
Figure 9.12