User Manual
Table Of Contents
- Safety Notices
- Section 1
- Section 2
- Installation
- Indigo® NXT or Indigo® Model 22" & 30" Wide Single Evaporator Installation
- Indigo® NXT or Indigo® Model 48" Wide Single Evaporator Installation K00451 Indigo® & K00465 Indigo® NXT
- Indigo® NXT or Indigo® Two-Evaporator Ice Machine Model Installation K00434, K00451 Indigo® & K00465 Indigo® NXT
- NEO® Undercounter Model Installation
- Ice Beverage (IB) Single Evaporator Model Installation
- Installation
- Section 3
- Blank Page
Part Number: 000014110 Rev 01 1/19 11
Section 2 Installation
K00424, K00434, K00440, K00450, K00451,
K00452 INDIGO® MODEL POWER SUPPLY
INSTALLATION PROCEDURE
30" Model Power Supply Mounting
Mount power supply on evaporator
bulkhead above control box. Attach
supplied wire clip and route line voltage
wires through clip.
22" Model Power Supply Mounting
The power supply for the 22" model
mounts behind the control board, below
the access fittings. Route line voltage wires
(black & white) through line voltage Heyco
fitting and attach to L1 and L2 contactor
terminals.
1. Route low voltage wiring (black and
yellow wires) to the LuminIce®. Install
wire clip and route wires close to
evaporator bulkhead to assure harness
is away from any moving parts,
then snap wire harness connectors
together.
2. Route the line voltage wires (black &
white) through line voltage Heyco
fitting and attach to L1 and L2
contactor terminals.
Attach Wire Clip
Route Line Voltage Wires Through Clip
Install Power
Supply
Route Through Line Voltage Heyco
and
Attach to Contactor Terminals