Service manual

Installation and Service Manual

COMPONENT DIAGNOSTICS

PROXIMITY SWITCH VOLTAGE CHECK

3 Relay Circuit Board Proximity Switch Check Procedure

NOTE: These checks should be done with proper

line voltage.

Set the multi-meter to read D.C. voltage - turn the

ice machine toggle switch to the center (off) position.

Disconnect the Red, White and Black leads of the prox-

imity switch from the control board. Turn the toggle switch

to the up position (ice). Check for voltage at the positive

and negative terminals on the control board.

NOTE: Voltage above 24 VDC will damage proximity

switch - replace both the control board and

proximity switch.

Voltage below 13 VDC proximity switch will

be intermittent - replace control board.