Service manual

Installation and Service Manual

INSTALLATION

WATER CURTAIN ADJUSTMENT

The water curtain acts as a shield to prevent the

water circulated across the evaporator from teh splash-

ing into the bin, resulting in additional make up water

being required.

To adjust, the screws holding the curtain bracket and

pin assembly must be loosened, left and right side. The

bracket assembly will allow the curtain to be adjusted

5/16" (8mm) up or down and front to rear. the bottom

edge of the curtain should be set to clear the water pan

by a maximum of 1/8" (.32cm). Normal adjustment, front

to rear, would be to adjust the curtain in as far as pos-

sible.

Adjustment must also observe side to side travel of

curtain. Any side to side movement of 1/16" (.16cm) or

greater must be shimmed out as this would create er-

ratic operation of proximity and/or Hall switch.

NOTE: Be certain water pan is properly seated on

it's support blocks

before adjusting water curtain.