User Manual
Table Of Contents
 DANGER
Follow these precautions to prevent personal injury during use and maintenance of this 
equipment:
•  It is the responsibility of the equipment 
owner to perform a Personal Protective 
Equipment Hazard Assessment to ensure 
adequate protection during maintenance 
procedures. 
•  Do Not Store Or Use Gasoline Or Other 
Flammable Vapors Or Liquids In The 
Vicinity Of This Or Any Other Appliance. 
Never use flammable oil soaked cloths 
or combustible cleaning solutions for 
cleaning.
•  All covers and access panels must be 
in place and properly secured when 
operating this equipment.
•  Risk of fire/shock. All minimum 
clearances must be maintained. Do not 
obstruct vents or openings. 
•  Failure to disconnect power at the main 
power supply disconnect could result 
in serious injury or death. The power 
switch DOES NOT disconnect all incoming 
power.
•  All utility connections and fixtures must 
be maintained in accordance with the 
authority having jurisdiction.
•  Turn off and lockout all utilities (gas, 
electric, water) according to approved 
practices during maintenance or 
servicing.
•  Units with two power cords must be 
plugged into individual branch circuits. 
During movement, cleaning or repair it is 
necessary to unplug both power cords.
•  Never use a high-pressure water jet for 
cleaning on the interior or exterior of 
this unit. Do not use power cleaning 
equipment, steel wool, scrapers or wire 
brushes on stainless steel or painted 
surfaces. 
•  Two or more people are required to 
move this equipment to prevent tipping.
•  Locking the front casters after 
moving is the owner’s and operator’s 
responsibility. When casters are installed, 
the mass of this unit will allow it to move 
uncontrolled on an inclined surface. 
These units must be tethered/secured to 
comply with all applicable codes. 
•  The on-site supervisor is responsible for 
ensuring that operators are made aware 
of the inherent dangers of operating this 
equipment.
•  Do not operate any appliance with a 
damaged cord or plug. All repairs must 
be performed by a qualified service 
company.










