User Manual
Table Of Contents
Part Number 000014141 Rev 07 2/20  39
Section 3  Operation
Ice Making Sequence of Operation
The power button must be depressed and 
the water curtain/ice dampers must be 
in place on the evaporator before the ice 
machine will start.
Water Purge Cycle
The ice machine purges any remaining 
water from the water trough down the 
drain.
Prechill Cycle
The refrigeration system cools the 
evaporator before the water pump is 
energized.
Freeze Cycle
Water flows across the evaporator and the 
refrigeration system chills the evaporator. 
Ice builds on the evaporator and the freeze 
cycle continues until the ice thickness 
probe senses a sheet of ice has formed. 
The ice thickness probe signals the control 
board to start a harvest.
Harvest Cycle
Any remaining water is purged down 
the drain as refrigerant gas warms the 
evaporator. When the evaporator warms, 
the sheet of cubes slides off the evaporator 
and into the storage bin. If all cubes fall 
clear of the water curtain (or ice damper) 
the ice machine starts another freeze cycle.
Off Cycle
If the water curtain or ice damper are held 
open by ice cubes the ice machine shuts 
off. When the water curtain or ice damper 
closes, the ice machine starts a new cycle at 
the water purge. 
Control Board Timers
The control board has the following non-
adjustable timers:
•  The ice machine control board will set 
its own install date after 100 freeze and 
harvest cycles.
•  The ice machine is locked into the freeze 
cycle for 6 minutes before a harvest cycle 
can be initiated. 
•  The maximum freeze time is 35 
minutes at which time the control 
board automatically initiates a harvest 
sequence.
•  The maximum harvest time is 7 minutes, 
the control board will perform a water 
thaw cycle and then return the ice 
machine to the freeze cycle.
Service Faults
Service Faults are stored and indicated by 
the control board after three cycles. The 
number of cycles required to stop the ice 
machine varies for each Service Fault. 
•  Long Freeze Cycle - If the freeze time 
reaches 35 minutes, the control board 
automatically initiates a harvest cycle. 
If 6 consecutive 35 minute freeze cycles 
occur, the ice machine stops.
•  Long Harvest Cycle - If the harvest time 
reaches 7 minutes, the control board 
automatically returns the ice machine to 
the freeze cycle. After 3 consecutive long 
harvest cycles the ice machine stops.
Refer to Section 5 if you receive an alert for  
Service Fault E01 or E02.










