Service Manual

Part Number: 000015430 Rev 02 5/20 139
PROGRAMMING A REPLACEMENT CONTROL BOARD
Indigo™ replacement control boards require the Model
number to be entered to activate the appropriate look up
tables for operation and diagnostic. This can be done two
different ways, USB Setup or Manual Setup.
USB Setup - Applicable when the control board is
operational and has a mechanical issue such as a sticking
relay. The asset data is transferred to the replacement
control board from the faulty control board. Refer to
 “Exporting Data To A Flash Drive” before
installing the replacement board.
Manual Setup - Applicable when the control board is non-
operational or data from the faulty board is suspect.
1. Install replacement control board and reapply power.
2. Navigate to control board replacement and follow the
on screen prompts:
Menu/Service/Control Board Replacement.
NOTE: If a replacement control board is installed into
the ice machine without a display and model number.
The “Test/Display Bypass Button” push button can still
activate the ice making mode without the display. This
will allow the ice machine to temporary run until a new
display can be installed. Once a new display is installed the
correct model number will have to be entered into the ice
machine.