User Manual

48 Part Number 000014141 Rev 07 2/20
Maintenance Section 4
Remedial Cleaning Procedure
This procedure descales all components in
the water flow path, and is used to descale
the ice machine between the bi-yearly
detailed descaling and sanitizing procedure.
Ice machine cleaner/descaler is used to
remove lime scale and mineral deposits. Ice
machine sanitizer disinfects and removes
algae and slime.
NOTE: Although not required and
dependent on your installation, removing
the ice machine top cover may allow easier
access.
Step 1 Ice must not be on the evaporator
during the clean/sanitize cycle. Follow one
of the methods below:
• Press the power switch at the end of
a harvest cycle after ice falls from the
evaporator(s).
• Press the power switch and allow the ice
to melt.
Notice
Never use anything to force ice from the
evaporator. Damage may result.
Step 2 Open the front door to access the
evaporator.
Step 3 Press the Clean button and
select “Make ice when complete”. Water
will flow through the water dump valve
and down the drain. Wait approximately
1 minute until the water trough refills and
the display indicates Add Chemical. Add the
proper amount of ice machine descaler to
the water trough by pouring between the
water curtain and evaporator, then confirm
the chemical was added.
Model
Amount of
Cleaner/Descaler
IF0300/IT0420
IP0520/IT0620
3 oz
(90 ml)
IT0450/IT0500/IF0500
IP0500/IF0600
IT0750/IF0900/IT0900
IT1200
5 oz
(150 ml)
IBF0620C/IBF0820C
IBT1020C
5 oz
(150 ml)
IF1400C/IT1500
IF1800C
IT1900/IF2100C
9 oz
(265 ml)
Step 4 Close and secure the front door.
The ice machine will automatically start
ice-making after the clean cycle is complete
(approximately 24 minutes).