Installation Guide

44 Part Number: 000014141 Rev 03 2/18
Maintenance Section 4
Preventative Maintenance Cleaning
Procedure
This procedure cleans all components in
the water flow path, and is used to clean
the ice machine between the bi-yearly
cleaning/sanitizing procedure.
Ice machine cleaner is used to remove lime
scale and mineral deposits. Ice machine
sanitizer disinfects and removes algae and
slime.
NOTE: Although not required and
dependent on your installation, removing
the ice machine top cover may allow easier
access.
Step 1 Ice must not be on the evaporator
during the clean/sanitize cycle. Follow one
of the methods below:
• Press the power switch at the end of
a harvest cycle after ice falls from the
evaporator(s).
• Press the power switch and allow the ice
to melt.
Notice
Never use anything to force ice from the
evaporator. Damage may result.
Step 2 Open the front door to access the
evaporator.
Step 3 Press the Clean button and select
“Make ice when complete”. Water will flow
through the water dump valve and down
the drain. Wait approximately 1 minute
until the water trough refills and the display
indicates Add Chemical. Add the proper
amount of ice machine cleaner to the water
trough by pouring between the water
curtain and evaporator, then confirm the
chemical was added.
Model
Amount of
Cleaner
IF0300/IT0420/IT0620
3 oz
(90 ml)
IT0450/IT0500/IF0600
IF0900/IT1200
5 oz
(150 ml)
IBF0620C/IBF0820C
IBT1020C
5 oz
(150 ml)
IF1400C/IT1500/IF1800C
IT1900/IF2100C
9 oz
(265 ml)
Step 4 Close and secure the front door.
The ice machine will automatically start
ice-making after the clean cycle is complete
(approximately 24 minutes).