Installation Guide

Part Number: 000014141 Rev 03 2/18 29
Section 2 Installation
Starting the Ice Machine
Starting the ice machine and completing
the Operational Checks are the
responsibilities of the owner/operator.
Adjustments and maintenance procedures
outlined in this manual are not covered by
the warranty.
REMOVE ICE THICKNESS PROBE
SHIPPING BRACKETS.
Remove and discard shipping brackets
before starting the ice machine.
Step 1 Ice machine must be programmed
refer to “Touch Screen Features” on page
31 for details.
Step 2 Refer to “Cleaning/Sanitizing
Procedure” on page 40 and sanitize
the ice machine and bin before placing in
operation.
Step 3 Refer to “Ice Making Sequence of
Operation” on page 35 for operational
details.
MINIMUM/MAXIMUM SLAB WEIGHT
Adjust ice thickness to maintain the correct
bridge thickness and “Minimum/Maximum
Slab Weight” on page 37.
Remote Ice Machine Usage with Non-
Manitowoc Multi-Circuit Condensers
Warranty
The sixty (60) month compressor warranty,
including thirty six (36) month labor
replacement warranty, shall not apply when
the remote ice machine is not installed
within the remote specifications. The
foregoing warranty shall not apply to any
ice machine installed and/or maintained
inconsistent with the technical instructions
provided by Manitowoc Ice. Performance
may vary from Sales specifications. ARI
certified standard ratings only apply when
used with a Manitowoc remote condenser.
If the design of the condenser meets the
specifications, Manitowoc’s only approval
is for full warranty coverage to be extended
to the Manitowoc manufactured part of
the system. Since Manitowoc does not
test the condenser in conjunction with the
ice machine, Manitowoc will not endorse,
recommend, or approve the condenser, and
will not be responsible for its performance
or reliability.
Important
Manitowoc warrants only complete
new and unused remote packages.
Guaranteeing the integrity of a new ice
machine under the terms of our warranty
prohibits the use of pre-existing (used)
tubing or condensers.