Service Manual
Table Of Contents
- Safety Notices
- Definitions
- General Information
- Installation
- Stacking Two Ice Machines on a Single Storage Bin
- Location of Ice Machine
- Clearance Requirements
- Dual Evaporator Model Installation on a Manitowoc Bin
- Ice Machine on a Dispenser Installation
- Water Supply and Drains
- Lineset Applications
- QuietQube® Remote Condensing Unit
- Additional Refrigerant Charge For 51' to 100' Line Sets
- Maintenance
- Operation
- Menu Navigation
- Component Check Procedures
- Control Board, Display And Touchscreen
- Operating an ice machine without a Touchscreen
- Control Board Relay Test
- Programming A Replacement Control Board
- USB Flash Drive Specifications and Formatting
- Exporting Data to a Flash Drive
- Upgrading Firmware with a Flash Drive
- Main Fuse
- Bin Switch
- Water Level Control Circuitry
- Ice Thickness Probe (Initiates Harvest)
- Bin Level Probe
- Thermistors
- High Pressure Cutout (HPCO) Control
- Low Pressure Cutout (LPCO) Control
- Compressor Time Delay
- Fan Cycle Control
- Harvest Assist Air Pump
- Compressor Electrical Diagnostics
- Diagnosing Start Components
- Refrigeration Components
- Recovery/Evacuation/Charging Procedures QuietQube® Models
- System Contamination Clean-Up
- Total System Refrigerant Charge QuietQube® CVD Models
- Control Board, Display And Touchscreen
- Charts
- Diagrams
“Part Number: 000015431 Rev 02 6/20” 71
HOME SCREEN ICON DESCRIPTIONS
Icon Description
Home Screen Pressing this icon at any time will return the
display to the home screen.
State of ice Machine is the center portion of the
screen which displays the current condition of
the ice machine - Making ice, bin full, program
mode or machine off
Alert Alert icon with number of messages. Pressing
this icon will display the alert log which will
allow viewing and resetting of alerts
Message Message icon with umber of messages. Pressing
this icon will display the routine maintenance
reminder screen which will allow viewing and
resetting of the reminder
Menu Menu icon will take you to the main menu.
Note: This icon changes to a lock if the
touchscreen lock has been selected.
Information Information icon provides model and serial
number, installation date and other information
specific to the ice machine.
Service Locator Provides contact information for your local
service support - Default is the Manitowoc Ice
website service locator
Lock/Unlock Indicates if screen is locked or unlocked.
The icon is only visible when the screen is
locked.
LuminIce Only visible when a LuminIce II accessory is
connected.
Blue S - Normal operation
Red S - Replace bulb
Red/Blue alternating - Incorrect bulb installed
3
3
i
S