Service manual

Installation Instructions Section 2
2-4
Part No. 80-1206-3
Location of Ice Machine
The location selected for the ice machine must meet the
following criteria. If any of these criteria are not met,
select another location.
• The location must be free of airborne and other
contaminants.
• The air temperature must be at least 35°F (1.6°C),
but must not exceed 110°F (43.4°C).
• The location must not be near heat-generating
equipment or in direct sunlight.
Ice Machine Head Section Clearance
Requirements
Q0600C/Q0800C/Q1000C/Q1400C/QDUALC:
Top/Sides 5” (127 mm) is recommended for efficient
operation and servicing. There is no minimum clearance
required.
Back 1” (25.4 mm) required when routing electrical inlet,
water inlet and refrigeration tubing out of the top of the
unit.
5” (127 mm) required when routing all connections out
the back.
IB0600C/IB0800C/IB1000C:
Top 2” (51 mm) required clearance for cleaning
procedures and servicing.
Back 5” (127 mm) required when routing all connections
out the back.
Sides 8” (203 mm) required for servicing.
SU1000C/SerVend UC-300:
Top 40” (101.6 cm) required clearance for cleaning
procedures and servicing.
Back 12” (30.5 cm) required for cleaning procedures
and servicing.
Stacking Two Ice Machines on a Single
Storage Bin
Q0600C/Q0800C/Q1000C Ice Machines:
A stacking kit is required for stacking two ice machines.
Installation instructions are supplied with the stacking kit.
IB0600C/IB0800C/IB1000C/Q1400C/QDUAL:
Ice Beverage, Q1400C and QDUAL ice machines
cannot be stacked. However an adapter is available that
allows two Q1400C or QDUALC ice machines to be
placed side by side on a 60” Manitowoc F style bin.
Securing the Ice Machine to the Dispenser
IB0600C/IB0800C/IB1000C Only
Standard with IB ice machines and packaged in head
section is the dispenser thermostat kit, K-00209. It is
required that this kit be installed with all IB ice machines.
The thermostat kit must be installed before the adapter
and ice machine head section is installed.
The purpose of the thermostat kit is to reduce machine
overfill and condensation problems in high humidity
locations. It is recommended that bin level control be
used on all dispenser applications with timed agitation to
allow for better agitation in the bin.
The ice machine and adapter plate must be secured to
the dispenser to prevent tipping.
• Two holes are located in the front bottom rail of the
ice machine, to allow attachment to the adapter
plate.
• The adapter cover must be secured to the dispenser
to prevent ice from dislodging the cover during
agitation.
!
Caution
The ice machine head section must be protected if it
will be subjected to temperatures below 32°F (0°C).
Failure caused by exposure to freezing
temperatures is not covered by the warranty. See
“Removal from Service/Winterization”.
Important
Manitowoc Ice/Beverage Ice Machines require an
adapter for mounting. Adapters are not included
with the ice machine, dispenser or bin and must be
ordered separately. When a non-Manitowoc adapter
is used, verify the adapter is compatible with
Manitowoc Ice/Beverage Ice Machines prior to
installation.
!
Warning
The ice machine and adapter plate must be secured
to the dispenser to prevent tipping.