Service Manual
Table Of Contents
- General Information
- Model Numbers
- Installation
- Maintenance
- Troubleshooting
- Component Check Procedures
- Electrical Components
- Main Fuse
- ICE/OFF/CLEAN Toggle Switch
- Float Switch
- Ice Damper and Hall Effect Switches
- Selector Switch
- Dispense Lever Activated
- Touchless Sensor Activated
- Dispense Switch
- Touchless Sensor
- High Pressure Cutout Control
- Fan Cycle Control
- Low Pressure Cutout (LPCO) Control
- Compressor Electrical Diagnostics
- Diagnosing Start Components
- Refrigerant Recovery/Evacuation
- System Contamination Clean-Up
- Electrical Components
- Component Specifications
- Charts
- Diagrams
80 Part Number 000015432 4/18
DISPENSE SWITCH
FUNCTION
Supplies power to the product selector switch when
activation lever is depressed.
CHECK
1. Inspect the selector switch for correct wiring.
2. Isolate the switch by disconnecting all wires from the
switch.
3. Check across the switch terminals with an ohm meter.
Activation Lever Position Resistance Reading
Depressed Closed
Released Open
Replace the selector switch if ohm readings do not match.