Service Manual
Table Of Contents
- General Information
- Model Numbers
- Installation
- Maintenance
- Troubleshooting
- Component Check Procedures
- Electrical Components
- Main Fuse
- ICE/OFF/CLEAN Toggle Switch
- Float Switch
- Ice Damper and Hall Effect Switches
- Selector Switch
- Dispense Lever Activated
- Touchless Sensor Activated
- Dispense Switch
- Touchless Sensor
- High Pressure Cutout Control
- Fan Cycle Control
- Low Pressure Cutout (LPCO) Control
- Compressor Electrical Diagnostics
- Diagnosing Start Components
- Refrigerant Recovery/Evacuation
- System Contamination Clean-Up
- Electrical Components
- Component Specifications
- Charts
- Diagrams
36 Part Number 000015432 4/18
Step 9 The ice machine will freeze and discharge the
sanitizing solution into the bin. Allow the cycle to run for
15 minutes.
Step 10 Discard all ice produced during the sanitizing
process.
Step 11 Place the toggle switch in the CLEAN position.
The ice machine will automatically time out a series of
flush and rinse cycles, and then stops. This entire cycle
lasts approximately 30 minutes.
Step 12 Refer to Component Disassembly for Cleaning
and Sanitizing and remove, clean and sanitize all parts
listed.