Service Manual
Table Of Contents
- General Information
- Model Numbers
- Installation
- Maintenance
- Troubleshooting
- Component Check Procedures
- Electrical Components
- Main Fuse
- ICE/OFF/CLEAN Toggle Switch
- Float Switch
- Ice Damper and Hall Effect Switches
- Selector Switch
- Dispense Lever Activated
- Touchless Sensor Activated
- Dispense Switch
- Touchless Sensor
- High Pressure Cutout Control
- Fan Cycle Control
- Low Pressure Cutout (LPCO) Control
- Compressor Electrical Diagnostics
- Diagnosing Start Components
- Refrigerant Recovery/Evacuation
- System Contamination Clean-Up
- Electrical Components
- Component Specifications
- Charts
- Diagrams
Part Number 000015432 4/18 29
ICE
WATER
ICE /
WATER
Add solution here
Step 3 The ice machine will run a wash cycle, a series
of rinse cycles and then stop. This entire cycle lasts
approximately 30 minutes.
NOTE: Periodic cleaning must be performed on adjacent
surface areas not contacted by the water distribution
system.
NOTE: The ice machine may be set to start and finish
a cleaning procedure, and then automatically start ice
making again
A. After cleaner is added, move the switch from
CLEAN to ICE position.
B. When the cleaning cycle is complete, ice making
will start automatically.