Specifications

Installation Instructions Section 2
2-2
Location/Mounting
CAUTION
Do not install in an area where the air temperature
falls below 35F or exceeds 110F.
The AuCS

must be protected if it will be subjected
to temperatures below freezing. Refer to “Removal
From Service/Winterization.”
HEIGHT REQUIREMENT
(Refer to drawing on page 2-3.) Either the base or the
top of the AuCS

must be within 2” of the base of the
ice machine. Do not mount the AuCS

too high or
too low.
CAUTION
The cleaner or sanitizer may siphon (or dispense
improperly)into the ice machine water trough if the
AuCS

is mounted too high or too low.
DISTANCE REQUIREMENT
(Refer to drawing on page 2-3.) The AuCS

must be
mounted within 9 feet of the ice machine to
accommodate the low voltage modular wire and
tubing. The tubing may be shortened to accommodate
a run of less than 9 feet.
CAUTION
Do not extend the length of the 9-foot low voltage
modular wire or tubing. The correct amount of
solution will not dispense.
FASTENING TO BIN OR DISPENSER
CAUTION
The AuCS

accessory may be mounted to the bin
or dispenser only when permitted by local electrical
codes.
NOTE: The ice machine’s serviceability may be
reduced when the AuCS

is mounted to the bin or
dispenser. Wall mounting is recommended.
1. Set the mounting bracket (part F, page 2-4) over
the bin top rail at desired location (refer to
figure).
2. Remove the backing from the foam adhesive tape
(part E, page 2-4). Apply tape to mounting
bracket, and along the entire bin rail.
3. Align the AuCS

key slots with the mounting
bracket tabs. Verify the tabs are at the top of the
key slots and that the AuCS

is level.
4. Remove the backing from the adhesive bumpers
(part D, page 2-4.) Attach bumpers to the
mounting bracket directly above the AuCS

control box. This eliminates upward movement
and stops the tabs from disengaging the key slots.
GASKET
BRACKET
Mounting to Ice Machine
FASTENING TO WALL
The AuCS

is mounted to the wall using the two key
slots in the back wall of the accessory. Screw
fasteners (not supplied) must hold the entire weight
of the AuCS

accessory (approximately 10 lb.).
Key Slot Dimensions
SV1640G
BUMPER
SV1634G
6-9/16”