Specifications

Maintenance Section 4

Part Number 000007345 2/12

Preventative Maintenance Cleaning

Procedure

This procedure cleans all components in the water flow

path, and is used to clean the ice machine between the

bi-yearly cleaning/sanitizing procedure.

Ice machine cleaner is used to remove lime scale and

mineral deposits. Ice machine sanitizer disinfects and

removes algae and slime.

NOTE: It is not required to remove the ice from the bin/

dispenser during this cleaning procedure.

Step 1 Ice must not be on the evaporator during the

clean/sanitize cycle. Follow one of the methods below:

• Press the power switch at the end of a harvest cycle

after ice falls from the evaporator(s).

• Press the power switch and allow the ice to melt.

Step 2 Open the front door to access the evaporator.

Step 3 Press the clean switch. Water will flow through

the water dump valve and down the drain. Wait until the

water trough refills and the display indicates add solution

(approximately 1 minute), then add the proper amount of

ice machine cleaner.

Step 4 Close and secure the front door. The ice

machine will automatically start ice making after the

clean cycle is complete (approximately 24 minutes).

Door Removal

1. Use a phillips screwdriver to loosen the two screws

securing the door. Do not remove they are retained

to prevent loss.

2. Open left front door to 90 degrees. .

Door Removal

3. Support with right hand, depress top pin, tilt top of

door forward and lift out of bottom pin to remove.

Caution

Never use anything to force ice from the evaporator.

Damage may result.

Model Amount of Cleaner

I0300/I0320/I0520 3 ounces (90 ml)

I0450/I0500/I0600

I0850/I1000/I1200

5 ounces (150 ml)

I1400/I1600/I1800 9 ounces (265 ml)

I3300 16 ounces (475 ml)