Installation Guide

40 Part Number STH14 9/10
QUICKDRAW INSTALLATION
NOTE: The Quickdraw unit requires a supply of CO
2
.
The pressure requirement for the CO
2
supply is
75 psig (5.17 bar). The adjustable Ice Dispense CO
2
regulator in the electric box must be set at 40 to 45 psi
(2.76 to 3.10 bar). The Ice Dispense CO
2
Regulator
must never be set above 45 psi (3.10 bar).
Turn CO
2
supply on to the dispenser. Each cold carb
pump deck is furnished with a fixed regulator set at
75 psi (5.17 bar). Ambient units need to be set
between 90 and 105 psi (6.24 and 6.90 bar).
BACK ROOM PACKAGE
Incoming tap water — Must be at a minimum
dynamic pressure of 40 psi (2.76 bar) and maximum
static pressure of 65 psi (4.48 bar). If pressure can not
be attained, a water booster may be needed.
Carbonator Water pump motor — Powers the water
pump. The water pump motor is part of the carbonator
pump deck.
Carbonator Water pump — Pumps tap water into the
carbonator tank. The water pump is part of the
carbonator. The incoming water for the carbonator
must be first run through the pump before connecting
to the proper cold plate inlet.
! Warning
Personal Injury
Hazardous Moving Parts
Do not adjust regulator valve above 50 psig
(3.45 bar).
Recommended operating parameters are
40 - 50 psig (2.76 - 3.45 bar).
Important
The ice portion sizes must be adjusted to
customer requirements at the time of installation.
(See the Quickdraw Ice Portion Adjustments
section for more information.)
STH14.book Page 40 Thursday, September 23, 2010 3:35 PM