Installation Guide
Table Of Contents
- General Information
- Installation
- Component Identification
- Maintenance
- Operation
- Blade Tower Brixing
- CEV Electronic Ice & Carbonation Control
- Flavor Magic Programming
- Flav’R-Pic External Programming
- Flav’R-Pic (FRP-250) Programming
- Flav’R-Pic (FRP-250) Brixing Procedure
- FlexTower Programming Modes
- Control Board Run or Dispense Mode
- The 6 Programming Modes on FlexTower Control Board
- To Access Programming Modes
- To Exit Programming Modes
- Manual Dispense Mode
- Timed Dispense Mode (Flavor Adder Dispensed)
- Water Calibration Mode
- Syrup Calibration Mode
- Touchpad Configuration Mode
- Touchpad LED Light Sequencing Mode (8 Selection Area Touchpad)
- Touchpad LED Light Sequencing Mode (4 Selection Area Touchpad)
- Adjustments
- Agitation Timer
- Troubleshooting
- Component Specifications
- Charts
- Diagrams
- Blade Tower Plumbing
- CEV-30i & CEV-30e Plumbing
- CEV-40i & CEV-40e Plumbing
- CT-6 Plumbing and Wiring
- CT-8 Plumbing and Wiring
- CF-1522 Plumbing
- DI-1522 Post-mix Plumbing
- DI-1522 Pre-mix Plumbing
- DI/DIL-2323 6 Valve Post-mix Plumbing
- DI/DIL-2323 8 Valve Post-mix Plumbing & Variety Valve
- DI/DIL-2323 10 Valve Post-mix Plumbing
- DI/DIL-2323 6 Valve Pre-mix Plumbing
- Flavor Magic Plumbing
- FRP-250 Plumbing Diagram
- FRP-250 & FRP-250SCI Tubing Layout
- FT-8 Plumbing
- FT-12 Plumbing
- FlexTower Water Recirculation Pump Flow
- FlexTower Water Chiller Flow
- MDH-302 12 Valve Plumbing
- MDH-402 16 Valve Plumbing
- MDH-402 20 Valve Plumbing
- S/SV150 6 Valve Diagram
- S/SV175 8 Valve Diagram
- S/SV200/250/SV-250QD 8 Valve Diagram
- S/SV200/250 10 Valve Diagram
- Flex Manifold Diagrams
- CEV Wiring
- CF Drop-In Series Wiring
- Drop-in Wiring
- Flavor Magic Wiring
- Flav’R-Pic (FRP-250) Wiring
- FlexTower Wiring
- MDH-302 & MDH-402 Wiring
- NGF-250 Wiring
- quickdraw Wiring
- S/SV/SVi Wiring
- Selectable Ice Wiring
Part Number STH14 9/10 179
NGF-250 & NGF-250QD 8 Valve Diagram
No Variety Vlv
Standard
CO
2
Valves
Cold Plate
Variety Valve
Block
Variety Valve
Keypad
W-Water
3-Flavor
2-Flavor
*A & *B are ambient syrup lines added for the 3rd variety valve.
Line to be plug when not in use.
Syrup line (5#)/Carb only line (C)/Manifold line (WC)
Externally carbonated units: carbonator tank is replaced by by-pass tube
For assistance call (812) 246-7000
Valve s
Circuits
Manifold: Change to carbonated or non-carbonated water.
1. Rotate plunger 180° using a 5/32" Hex Key wrench.
2. Pull plunger up to get non-carbonat ed water.
3. Push plunger down to get carbonated water.
4. Turn plun ger back 180° to lock.
5. Port 5 is not used.
Internal
Carbonator
Ta nk
(Optional)
Carbonator out to Po st-Chill
Vlv 1, 2, & 6
Pre-Chill Out to Carbonator
*
w/1 Variety Vlv
Valves
w/2 Variety Vlvs
Valves
w/3 Variety Vlvs
Valves
1-Flavor
Syrup #12
Syrup #11
Syrup #10
Syrup #9
Syrup #8
Syrup #7
Syrup #6
Syrup #5
Syrup #4
Syrup #3
Syrup #2
Syrup #1
Plain Water
Plain Water to
Carbonator
Syrup #12
Syrup #11
Syrup #10
Syrup #9
Syrup #8
Syrup #7
Syrup #6
Syrup #5
Syrup #4
Syrup #3
Syrup #2
Syrup #1
Plain Water
Plain Water to
Carbonator
Syrup #12
Syrup #11
Syrup #10
Syrup #9
Syrup #8
Syrup #7
Syrup #6
Syrup #5
Syrup #4
Syrup #3
Syrup #2
Syrup #1
Plain Water
Plain Water to
Carbonator
Syrup #12
Syrup #11
Syrup #10
Syrup #9
Syrup #8
Syrup #7
Syrup #6
Syrup #5
Syrup #4
Syrup #3
Syrup #2
Syrup #1
Plain Water
Plain Water to
Carbonator
STH14.book Page 179 Thursday, September 23, 2010 3:35 PM