User Manual

38 Part Number 020003996 3/15
Maintenance Section 4
8. Using the sanitizing solution, a soft bristle brush, or a
clean cloth, sanitize the components listed in Step 5.
The ice chamber must be sanitized with a soft bristle
brush to adequately clean the drainage area.
9. Reverse the procedure to reassemble the Quickdraw
mechanism.
10. Place the ice dispense switch to the AUTO position, and
place the beverage valve switch to the ON position.
11. Check for proper operation.
NONFRONT SERVICEABLE GEAR MOTOR REMOVAL
These instructions are provided as a guide for the removal
of the gear motor. Depending on the model number of your
dispenser, these instructions may vary slightly.
1. Disconnect power from the electric receptacle.
2. Remove all ice from the ice storage bin of the dispenser.
3. Remove the paddle wheel pin from the paddle wheel
agitator assembly inside the dispenser bin.
4. Remove the agitator assembly from the dispenser bin
by pushing the agitator to the back of the bin. Angle
the front of the agitator to the side. Pull the agitator
forward then out of the dispenser.
5. Remove the paddle wheel from the dispenser by
pulling the hub of the paddle wheel to the back of the
bin and off the gear motor shaft.
6. Remove the splash panel from the dispenser and
expose the gear motor.
7. Disconnect the electric connector from the gear motor
wire leads.
8. Remove the pin in front of the gear motor.
9. You must be able to remove the gear motor from the
dispenser.
10. To install a replacement gear motor, reverse this
procedure.
Removable Front
Merchandiser Panel
Beverage Valve
(Option)
Water
Line
Gear
Motor
Drain
Pan
Ice
Paddle
Wheel
Rocking Chute
Ice Dispense
Chute
Ice
Bin
Agitator