User Manual

36 Part Number 020003996 3/15

Maintenance Section 4

7. Remove agitator arm and paddlewheel pin.

Non-front Serviceable Motor

a. Rotate the agitator arm so the paddle wheel pin

handle is pointing up, toward the ceiling.

b. Prepare agitator pin for removal by removing the

stainless steel split ring.

c. Then remove the paddle wheel pin from the hole

in the agitator.

d. Push the agitator bar toward the back of the unit

until the agitator is free of the paddle wheel hub.

Front Serviceable Motor

a. With agitator arm in any position remove hitch clip

pin from the mushroom bushing on the rear of the

ice bin.

b. Push the agitator bar toward the bushing to

remove it from the paddle wheel hub.

NOTE: If a top mount ice machine is installed, sliding the

ice machine to one side will make bin component removal

easier. If the ice machine is hard plumbed it will need to be

disconnected.

Non-front Serviceable

Front Serviceable

8. Remove paddle wheel, bin liner and paddle wheel area.

9. Move the front of the agitator to one side and slide the

agitator forward until the rear of the agitator shaft is

clear of the bushing.

10. Remove the agitator from the bin area.

11. Slide the paddle wheel from its shaft.

12. Loosen the four knurled fasteners that hold the bin

liner in place.

13. Remove the bin liner.

14. Remove the paddle wheel area from the bin.

15. Discard the remaining ice in the bin.

DISASSEMBLE THE ROCKING CHUTE

NOTE: For all Quickdraw units, refer to Quickdraw

Components in this section for ice chute information.

1. Loosen the two knurled fasteners that hold the

merchandiser in place.

2. Remove the merchandiser.

3. Remove outer bracket.

4. Remove door lock.

5. Remove door.

6. Remove ice chute.

Ice Chute Removal