User Manual

Part Number 020003996 3/15 13
Section 2 Installation
n
Warning
When using electric appliances, basic precautions must
always be followed, including the following:
a. Read all the instructions before using the
appliance.
b. To reduce the risk of injury, close supervision
is necessary when an appliance is used near
children.
c. Do not contact moving parts.
d. Only use attachments recommended or sold by
the manufacturer.
e. Do not use outdoors.
f. For a cord-connected appliance, the following
shall be included:
• Do not unplug by pulling on cord. To unplug,
grasp the plug, not the cord.
• Unplug from outlet when not in use and
before servicing or cleaning.
• Do not operate any appliance with a
damaged cord or plug, or after the appliance
malfunctions or is dropped or damaged in
any manner. Contact the nearest authorized
service facility for examination, repair, or
electrical or mechanical adjustment.
g. For a permanently connected appliance — Turn
the power switch to the off position when the
appliance is not in use and before servicing or
cleaning.
h. For an appliance with a replaceable lamp —
Always unplug before replacing the lamp.
Replace the bulb with the same type.
i. For a grounded appliance — Connect to a
properly grounded outlet only. See Grounding
Instructions.
PUMP DECK WIRING
The supply cord is equipped with a three-prong 5-15P.
When a Ground Fault Circuit Interrupter (GFCI) is required
by code, a breaker type protector must be used. We do
not recommend GFIC outlets as they are known for more
intermittent nuisance trips than panel breakers. To ensure
both the safety and proper operation of this equipment, be
certain that the electrical receptacle is a proper design so as
to accept this plug, ensuring that the carbonator assembly
is properly grounded.
If the pump deck is to be installed in an area or community
whose local codes require permanent wiring, the following
procedure must be followed.
1. The three wires (white, black and green) must be fed
through the cable connector and brought into the
wiring compartment. The cable must be secured into
the connector.
2. The green wire from the cable must be connected to
the green screw that attaches to the inside panel of
the wiring compartment. Be sure to use a ring torque
terminal for connecting the wire to the screw.
3. The white wire from the cable must be joined to the N
terminal of the liquid level control board by a suitable
U.L. listed insulated cable connector.
4. The black wire from the cable must be joined to the L1
terminal of the liquid level control board by a suitable
U.L. listed insulated cable connector.