User Manual

Part Number 020003996 3/15 37
Section 4 Maintenance
QUICKDRAW COMPONENTS
1. Turn the beverage valve switch on the front left side to
the off position.
Ice Dispense Switch
Beverage Valve
Switch
2. Place a receptacle (bucket or large cup) under the ice
dispense chute.
3. Place the ice dispense switch to MANUAL mode. The
door will open and ice will fall into the bucket or cup.
4. Remove the ice chute cover:
A. Grab the tabs on the back of chute and spread,
pulling tabs off of pins.
B. Push the bottom of chute to rear until it stops.
C. Rock the top of the chute forward until top of
chute clears unit.
5. Mix a solution of mild detergent to clean the Quickdraw
components. Using the detergent solution and a
soft bristle brush or clean cloth, clean the following
components:
• Cup locator
• Quickdraw chamber
• Door
• Ice chute cover
6. Rinse all parts in clean running water.
7. Mix a sanitizing solution of 1/4 ounce (7.5 mil) liquid,
unscented bleach (5.25% CL NaO concentration) for
each gallon (7.6 liters) of water. The mixture must
provide 100-PPM available chlorine.