Installation Instructions

13
Your T2•R remote can be programmed to control the following functions on your TV:
• Standby
• AV (input selection). On most TV remotes this is labelled ‘AV’, ‘SOURCE’, ‘INPUT’ or .
• Volume Up/Down
• Mute
IMPORTANT
• Please turn the volume up on your T2•R to maximum before you continue. If you do
not, the volume from your T2•R will always be lower than it should be.
• Some TV’s use non-standard remote signals and may not be supported.
Program your Manhattan Remote
To start, lay the T2•R and TV remotes flat on a table facing each other 2cm apart.
1. Press the bottom left (SUB) and right (AD) buttons on the T2•R remote for 3 seconds.
» The Standby button on the T2•R remote lights up blue.
2. Press the button on the T2•R remote you want to program: Volume Up, Volume Down,
Mute, AV or TV .
» The Standby button on the T2•R remote starts blinking.
3. Press and hold the matching button on the TV remote.
» If the button is programmed, the light from the Standby button on the T2•R remote
turns o and then goes solid again after about a second.
» If the button fails to be programmed, the light from the Standby button flashes on
and o 4 times to indicate an error and you are returned to the start of Step 2.
4. Repeat steps 2 and 3 for all the buttons to program.
5. Press OK on the T2•R remote to leave programming mode.
» The light from the T2•R remote’s standby button turns o.
Test each of the buttons with your TV. If one doesn’t work, repeat the steps to program it.
Reset Your Remote
To clear all programmed buttons and return them to their original state, hold the SUB and
buttons for 3 seconds until the LED blinks.
CONTROL YOUR TV
Manhattan T2•R Remote Your TV Remote
2cm