User manual
13
CONFIGURATION
13
On the next screen you can dene the maximum translation output power (Tx Power)
of the wireless adapter. While you would normally leave the setting as “Auto” or
“100%” in situations where you do not want to have your signal travel so far (e.g.,
because you live in an apartment building), you can choose a lower value. After
all, being able to receive a wireless signal is the rst step in a successful attempt
to break into the network. In other words: Why would you want to broadcast your
wireless signal all over your neighborhood when your wireless access at home
works ne when it’s set at “50%” for output power?
The option “Use RTS Threshold” is disabled by default. Unless you experience
problems with your wireless connection, or if the signal strength is generally very
low, this doesn’t need to be enabled. If you experience poor wireless performance,
you can try using values between 1200 and 500, and below 500 in severe cases.
The option “Use Fragment Threshold” has a similar impact on poor wireless
connections. By default it is disabled and should remain so. The fragmentation
threshold is used to set the maximum size of packets that a client will send. The
smaller the maximum sizes the better the reliability of the wireless connection, but
the performance is likely to decrease at lower levels.