User guide

To receive Freeview, you must
connect your Plaza HD•T2 receiver
to an appropriate TV aerial that
has been correctly installed. If your
aerial is unable to provide adequate
signal, it may need to be realigned.
Please consult a professional.
2
CONNECT TO AN AERIAL
Place your Plaza HD•T2 receiver on
a firm, level surface close to your
television, a mains electricity socket,
and the cable from the TV aerial.
Connect the cable from your TV
aerial to the ANT IN socket at the
back of the receiver.
Make sure your television is turned
off and connect the HDMI cable to
the HDMI socket on the rear of the
Plaza HD•T2 and to an HDMI socket
on your television. If your television
has no HDMI socket, then it must
be connected to the receiver by
SCART or RCA cable, and you will
not be able to watch Freeview
channels in high definition. If you
need more guidance, check your
television manual.
Plug the mains power lead from the
back of the receiver into an available
mains socket that is turned off.
3
PLUG IN
Remove the battery compartment cover
from the back of the Plaza HD•T2 remote
control by lifting it up while pushing the catch.
Insert the two AAA sized batteries as marked
on the inside of the compartment. Replace
the compartment cover.
Turn on your TV set and choose the HDMI
input (see your television manual).
Switch on the mains socket the Plaza HD•T2
is connected to. The power indicator light on
the front will illuminate blue to indicate the
receiver has been turned on successfully.
After a few seconds, step one of the freesat
installation process will be shown on the
television screen.
If you do not see this screen (pictured
opposite), please refer to the Troubleshooting
section in the main User Guide.
4
SWITCH ON
B4
5
TUNE IN
To use Apps like BBC iPlayer or YouTube, the Plaza
HD•T2 must be connected to your internet router or
hub using an ethernet cable (not supplied). Plug one
end of the ethernet cable into the ETHERNET socket
at the back of the Plaza HD-T2, and the other into
your hub or router. Make sure the connections are fully
pushed in - you’ll hear a click as they lock into place.
Consult your router or hub’s documentation for further
guidance.
When the first installation step is displayed,
use the and buttons to select the screen
type of your television (16:9 Widescreen or the
squarer 4:3 Traditional). Press the button
to highlight the HDMI Resolution selection
box, and then use the and buttons to
select the correct resolution for your television
(see your television’s manual for guidance, or
select 720p if unsure).
Press
to select “Next” and then press
to display the next installation step.
If you don’t see a picture because you selected
an incompatible resolution, press
to
return to the first step and select a different
HDMI resolution.
Your Plaza HD•T2 receiver will scan for
channels, displaying the total number of TV,
radio and data channels found. When the scan
is complete, press the button to display
the next installation step.
A PIN is required to enable and disable
parental guidance, access locked channels or
restore to factory default. Enter your choice
of PIN by pressing the required number button
(0, 1 … 9) for each of the four PIN digits. Press
to complete setup.
Setup is now complete. Your PIN number will
be displayed on-screen along with a reminder
to make a note of it. When ready, press
and enjoy your Plaza HD•T2.