User guide

38
Appendix A – Safety
POWER
Your receiver requires a 100V to 240V AC ~ 50Hz mains supply and is
tted with a moulded plug. The mains plug is used as the disconnect
device and shall remain readily operable. The USB port maximum load is
500mA under normal operation.
CABLES
Make sure all cables are positioned so they are not likely to be
walked on, crushed or damaged by things placed on or against
them. Pay particular attention to the power cable where it goes
into the socket and where it comes out of the receiver. Do not
connect or adjust cables to the receiver when it is plugged in.
TEMPERATURE AND MOISTURE
Use the apparatus only in moderate climates (not in tropical
climates). Do not allow it to get wet as this is dangerous. Do
not expose the apparatus to dripping or splashing. Do not place
objects filled with liquids, such as vases, on the apparatus.
HEAT AND FLAMES
Do not place the apparatus near to naked ames or sources of
intense heat, such as an electric re. Do not place naked ame
sources, such as lighted candles on the apparatus. Batteries shall
not be exposed to excessive heat such as sunshine, re or the like.
VENTILATION
Slots and openings in the receiver’s cover are for ventilation. Ensure
a minimum distance of 5cm around the apparatus for sufcient
ventilation. Ensure the ventilation is not impeded by covering the
ventilation opening with items such as newspapers, table-cloths,
curtains, etc. Failure to follow these instructions could lead to the
receiver overheating.
CLEANING
Unplug the receiver before you clean it with a lightly dampened
cloth. Do not use liquid or aerosol cleaners.
LIGHTNING
If there is a storm or lightning, unplug the receiver.
SERVICING
Make sure that anyone who services your receiver is qualied to do
so. Do not remove the cover yourself – you could get an electric shock.
REPLACEMENT PARTS
If your receiver needs repairing, make sure the person carrying out
the repair uses parts which are specied by us or which have the
same specications as the original part. Other parts may cause a
re, electric shock or other dangers.