User guide

To receive freesat you must
connect your Plaza HD•S2 receiver
to an appropriate satellite dish,
fixed in position and accurately
pointed at 28.2° East satellite
position.
For safety reasons and to provide
reliable reception, we strongly
recommend that the dish is
professionally installed. If you have
any questions about the dish, please
consult your installer.
2
CONNECT TO A DISH
Place your Plaza HD•S2 receiver
on a firm, level surface close to
your television, a mains electricity
socket, and the cable from the dish.
Connect the cable from your dish
to the LNB IN socket at the back of
the receiver.
Make sure your television is turned
off and connect the HDMI cable to the
HDMI socket on the rear of the Plaza
HD•S2 and to an HDMI socket on your
television. If you need more guidance,
check your television manual.
Plug the mains power lead from the
back of the receiver into an available
mains socket that is turned off.
3
PLUG IN
Remove the battery compartment cover
from the back of the Plaza HD•S2 remote
control by lifting it up while pushing the catch.
Insert the two AAA sized batteries as marked
on the inside of the compartment. Replace
the compartment cover.
Turn on your TV set and choose the HDMI
input (see your television manual).
Switch on the mains socket the Plaza HD•S2
is connected to. The power indicator light on
the front will illuminate blue to indicate the
receiver has been turned on successfully.
After a few seconds, step one of the freesat
installation process will be shown on the
television screen.
If you do not see this screen (pictured
opposite), please refer to the Troubleshooting
section in the main user guide.
4
SWITCH ON
B4
When the first installation step is displayed,
use the and buttons to select the screen
type of your television (16:9 Widescreen or the
squarer 4:3 Traditional). Press the button
to highlight the HDMI Resolution selection
box, and then use the and buttons to
select the correct resolution for your television
(see your television’s manual for guidance, or
select 720p if unsure).
Press
to select “Next” and then press
to display the next installation step.
When the signal lock is successful, press
to proceed to the next step. If the signal lock
fails, please see the Troubleshooting section
in the main user guide.
Enter your postcode, pressing the number
buttons an appropriate number of times
to produce the letters (printed above each
button) and numbers required, in the same
way as ‘texting’ on a mobile phone. You do not
need to enter a space. If you make a mistake,
the
button deletes the previous character.
Now press
once to confirm the postcode
and again to start the channel scan
.
Your Plaza HD•S2 receiver will take a couple of
minutes to find and store the freesat channels
available, displaying the total number of
freesat TV and radio channels found. Press
the
button to display the next installation
step.
Enter your choice of PIN (used to lock certain
channels and functions) by pressing the
required number button (0, 1 … 9) for each of
the four PIN digits. Press
to proceed to the
next step.
Setup is now complete. Your PIN number will
be displayed on-screen along with reminder to
make a note of it. When ready, press
and
enjoy watching freesat digital TV.
5
TUNE IN
To watch On Demand TV services including BBC iPlayer
and ITV Player, the Plaza HD-S2 must be connected
to your internet router or hub using an ethernet cable
(not supplied). Plug one end of the ethernet cable into
the ETHERNET socket at the back of the Plaza HD-
S2, and the other into your hub or router. Make sure
the connections are fully pushed in - you’ll hear a click
as they lock into place. Consult your router or hub’s
documentation for further guidance.