Specifications

5
PROGRAMMING THE RECEIVER
Programming the receiver is achieved through the various menus. In order to simplify
this, we will describe accessing a menu as below.
Press MENU key to access the main menu.
Press Down key to highlight Setup.
Press OK to confirm.
Press Down key to highlight Service Setup.
Press OK to confirm.
Enter the 4 digits PIN code (0000 on purchase).
Press Up/Down key to highlight a scan option (example; Full Scan Add New
Services).
Press OK to start the channel search. Following screen will appear showing the search
progress.
TUNING SERVICES FIRST TIME
After the welcome screen appears on the TV, press OK to start the automatic channel
search. Below screen will appear showing the search progress. When the search is
finished, the first channel will appear.
WEDGING / ADJUSTING THE ANTENNA
If no channels are found through your current antenna, it means that, it is probably
pointing towards an analogue only transmitter. If your area is covered by digital, it
means that the programs are coming from another transmitter. Hence you will have to
Connecting to VCR
Connect your VCR to the VCR SCART on your
receiver.
If the search has not found all the available channels
in your area, it probably means that you need to
better the installation. See next paragraph.
If no channels are found, it probably means that your
area may not be covered by the transmission or the
antenna is not pointing to the digital transmitter. See
next paragraph.