Specifications

4
13: TV/R To select TV or Radio mode.
14: FAV To access favorite list. Press several times to select the correct FAV list if you
have defined more than one. To exit the FAV mode, go to Menu / Favorites and select
OFF
15: EPG (Electronic Programs Guide) To view the program event details playing at the
time and the following ones.
16: Page Up & Down keys to select next page in the lists.
17: TEXT Displays the digital Tele-text service, if available.
18: Color keys to navigate in the digital Tele-text if broadcasted by the service
provider. The red key launches the digital Tele-text, if available.
19: AV To switch AV mode on or off for the TV. It allows you to view an analogue
channel on your TV whilst recording a digital channel from your receiver.
20: INFO To display information (channel name, program, next program etc) on the
current channel you are watching.
21: M/P To display a multi channel screen.
22: Volume UP & Down keys to adjust the sound volume.
The remote control requires two AAA 1.5V batteries. Ensure that these are fitted
correctly. Please do not dispose of used batteries in your domestic waste bins. You may
take them back to your point of sale and place them in the right container.
INSTALLATION
Connect the TV antenna directly to the ANT input of the receiver. Connect the TV using
SCART cable to the TV SCART outlet of the receiver (see below). Switch on the TV and
connect the receiver to the main source. Switch on the main power switch on rear panel
(C6) a red indicator appears on the receiver. Press STBY key on remote to switch on the
receiver, the red indicator will turn green and the welcome screen appear on the TV.
If this is not the case, please double-check the TV SCART connections and select the
correct A/V or EXT mode of your TV (refer to your TV manual).
Connecting to TV via the TO TV (Modulator output C1)
Connect to your TV with a UHF (co-axial) cable and switch on the receiver. Select a spare
channel on your TV and tune it to channel 64 or until you see the welcome screen. Finally
store the setting on your TV. The receiver is factory set to channel 64. To change the
output channel, see ADJUSTING OUTPUT SIGNAL TO TV on page 8.
A: Shows Screened CO-AXIAL cable for your
TV antenna. Replace this in case of poor
reception with a high quality cable.
B & C: By connecting the Modulator output
(B) TO TV to your TV and (C) LOOP OUT to
LOOP IN on the receiver, you will keep the
analogue channels on your TV. You can then
record a digital channel whilst watching
another analogue channel on your TV.
Connecting to TV via the TV SCART (C9)
For clear picture quality, connect receiver to
your TV with a full SCART cable. Select AV
input on your TV.