Specifications

3
C1: TO TV Connect this output to UHF input of your TV. This will allow you to tune your
TV to analogue terrestrial programs as well as to use the built-in modulator for viewing
the digital terrestrial programs.
C2: ANT LOOP IN TV aerial input to modulator.
C3: VIDEO Composite video output to connect to TV or AV monitor etc.
C4: AUDIO LEFT/RIGHT Audio outputs for connecting to a HI-FI system or to the TV
audio input.
C5: RS232 Connector for upgrading software via PC. Use NULL MODEM (female to
female) cable to connect to your PC.
C6: ON – OFF Main power on/off switch.
C7: ANT IN Terrestrial antenna input.
C8: ANT LOOP OUT If you want to use loop through, connect this output to ANT LOOP
IN connector.
C9: TV SCART RGB, CVBS and Audio L & R SCART output to connect to TV.
C10: VCR SCART Connect VCR or DVD player via a SCART cable to this connector.
C11: S/PDIF To connect your receiver to digital audio amplifier.
C12: Power Cord.
FRONT PANEL CONTROLS
REMOTE CONTROL FUNCTIONS
1: 0~9 To enter the channel number you wish to view
in normal use or to enter digital values when
programming.
2: STBY To switch receiver on or to standby.
3: MENU To enter the main menu or to go back to the
previous menu from a sub-menu.
4: Left & Right keys to navigate or modify various
parameters.
5: Up & Down keys to move up or down when in
menu.
6: PAUSE To pause the picture. Second press
resumes normal view.
7: S-T To access the subtitles selection menu. When
you activate the subtitles, they will appear after a
short while.
8: LIST To display the channel list.
9: AUDIO To select an alternative audio track.
10: EXIT To exit all menus and go back to the
channel you were watching.
11: MUTE Press once to stop the sound. Press it
again to restore the sound.
12: OK To validate a choice in the menus.
F1: STBY Power on/off
button.
F2: CHANNEL Channel
up/down buttons.
F3: Status indicators.
Red when the product is
on standby. Green when
it is switched on.