User manual

49
ADVANCED FUNCTIONS
address label of your device reads “aa-bb-cc-dd-ee-ff” or “aa:bb:cc:dd:ee:ff,” just
enter “aabbccddeeff” (without the quote marks).
Computer Name — With all the computers connected to the router listed in this
drop-down menu, you can select a name without checking its IP address.
Comment — Enter up to 16 alphanumerical characters to identify the MAC address,
such as “Room 2A Computer.” This is optional, and you can leave it blank.
Add — Click to add the MAC address and associated comment to the MAC address
ltering table.
Reset — Click to remove all entries (in either panel).
Current MAC Filtering Table — All existing MAC addresses in the ltering table.
Delete — You can select one or more MAC addresses to delete by checking the
“Select” box of those you want to delete, then clicking “Delete.”
Delete All — Click to delete all MAC addresses listed.
Enable IP Filtering — Check this box to enable IP address-based ltering, and
select “Deny” or “Allow” to determine the behavior of the IP ltering table. If you
select “Deny,” all IP addresses listed in the ltering table will be denied access
to the network; if you select “Allow,” only IP addresses listed in the ltering table
will be able to connect to the network; all other network devices will be rejected.
Add PC — Click to add a new IP address to the IP ltering table. Up to 20
addresses can be added. (Refer to section 3.3.1.1 Add PC below.)
Delete — You can select one or more IP addresses to delete by checking the “Select”
box of those you want to delete, then clicking “Delete.”
Delete All — Click to delete all IP addresses listed.