User manual
29
SYSTEM & NETWORK SETUP
Subnet Mask — Enter the subnet mask for this network.
802.1d Spanning Tree — Select “Enable” or “Disable” from the drop-down menu.
DHCP Server — Select “Enable” or “Disable” from the drop-down menu.
2.6.2 DHCP Server
These settings are only available when “DHCP Server” in the LAN IP section is
enabled, but will also affect wireless clients.
Lease Time — Choose a lease time (the duration that every computer can keep a
specic IP address) from the drop-down menu of every IP address assigned by
this router.
Start IP — Enter the start IP address of the IP range.
End IP — Enter the end IP address of the IP range.
Domain Name— Enter a domain name for your network. (optional)
NOTE: The number of the last eld (the “d” eld) of “End IP” must be greater than
“Start IP” and can’t be the same as the router’s IP address. Also, the rst three
elds of the IP address of “Start IP,” “End IP” and “IP Address” in the LAN IP
section (the “a,” “b” and “c” elds) should be the same.
RECOMMENDED VALUES
IP Address: 192.168.2.1
Subnet Mask: 255.255.255.0
802.1d Spanning Tree: Disabled
DHCP Server: Enabled
RECOMMENDED VALUES
Lease Time: Two Weeks (or “Forever” if
you have fewer than 20 computers)
St ar t IP: 19 2.16 8. 2.10 0
End IP: 192.168.2.200
Domain Name: (leave it blank)