Owner's manual

48
5.14 Telepen Parameters
A> Type of Code
<Full ASCll Mode>
%0 T8 0
Compressed Numeric
Mode
%0 T8 8
B> Check Digit Transmission
Do Not Calculate
Check Digit
%0 TN3
Calculate Check
Digit & Transmit
<Calculate Check Digit
& Not Transmit>
%0 TN7
%0 TN5
C> Set Up Code Length
To set the fixed length:
1. Scan the "Begin" label of the desired set.
2. Go to the Decimal Value Tables in Appendix A,
scan label(s) that represents the length to be
read.
3. Scan the "Complete" label of the desired set.
Repeat the steps 1 - 3 to set additional lengths.