User manual

3
INSTALLATION
Before installing the MLBX Wireless Laser Mobile Mini Mouse, make sure that the
Bluetooth protocol is available on your computer — either on the hard drive
or through a Bluetooth dongle inserted in a USB port — as indicated by the
Bluetooth icon (right), which typically appears in the desktop system tray.
Different software is available to enable installation. (Widcomm and IVT screen
images are presented in the procedures below as examples.) Otherwise, the built-
in Microsoft software can be used (the second connection procedure of the three
listed below in Bluetooth Connection).
1. Press the cover release and remove the battery compartment cover.
2. Insert the two included AAA rechargeable batteries, matching the +/– polarity
as marked inside the battery compartment.
3. Replace the cover so it snaps securely back in place.
4. If the Low Power LED ashes, charge the mouse by connecting it to the
computer with the included retractable USB cable. NOTE: The mouse can be
used while charging.
5. Set the Power switch on the underside to the On position to place the mouse
in Discovery mode.
6. Press the Connect button until the Low Power LED blinks slowly.
7. Open your computer’s Bluetooth utility (built into the operating system or
installed as a third-party utility) and scan for available Bluetooth devices.
8. When “Bluetooth Wireless Laser Mouse” displays, select it.
9. When prompted for a passkey, enter 0000. The operating system will detect
the new device and automatically install the driver(s), making the mouse
ready for use.


Connect
Power
Cover
release
Laser
LED
USB
port
Scroll wheel
DPI
Cover