User manual

5
OPERATION
ID Setup for Wireless Operation
With the mouse positioned near the receiver,
use a hard, narrow object (such as a pin or
a straightened paper clip) to press both ID
buttons: rst on the receiver; then, within
10 seconds, on the underside of the
mouse. Hold each button in for a full
second. The receiver light will ash rapidly
for a few seconds, then remain lit, indicating that the connection between
the receiver and the mouse has been made and the mouse is ready for
wireless operation.
Wired Operation
Where the use of wireless devices is restricted; or when the mouse is
low on power — the mouse can be operated as a wired device. With
the retractable cable connected to the front of the mouse, connect the
other end to the computer. If only a PS/2 port is available, an adapter
can be used.
Remember to place the receiver back in the mouse so you don’t lose it.
Battery Charging
While using the mouse, if the red Low Battery
LED ashes, re-charge or change the
batteries. To re-charge, connect the mouse
to the computer with a USB cable. The mouse
can be used while the batteries charge; a full
charge requires 8-10 hours. To stop charging,
unplug the cable. NOTE: The actual charging time depends on the
degree of the discharge.
5
ID connect
ID
buttons
Charge
connector
Low battery
Low
Battery
LED
Charge connector