User manual

installation

1. Set the Lock/Unlock switch on the end panel to the

Unlock position.

2. Slide the cover of the Drive Enclosure off the

base.

3. Carefully place your hard drive in the base of

the enclosure so a solid connection is made

with the 22-pin SATA connector.

4. Use the included screws and

screwdriver to secure the hard

drive in place (see the image

above), then slide the cover

of the enclosure back in place.

Place the device in the stand, if

desired.

5. Use the included USB

cable to connect the

enclosure to your

computer.

6. Use the included power adapter to connect the enclosure’s +12V jack to a

power source.

7. Set the On/Off switch to On when you’re ready to use the device. The LEDs on

either corner of the end panel will light to indicate either Power (top, as shown

above) or Activity.

NOTE: Also shown is the One-Touch Backup button (to the left of the On/Off

switch), which is explained in Software Installation.

One-Touch Backup button

Hole for

screw on

each side

of base