Hard Drive Docking Kit user manual Models 451109 & 451123 MAN-451109/451123-UM-0707-01
introduction Thank you for purchasing the MANHATTAN ® Hard Drive Docking Kit, Model 451109 or Model 451123 (aluminum case). The easy-to-follow instructions in this user manual help make setup and operation quick and simple, so you’ll also soon be enjoying the benefits of these additional features: • Easily converts any 3.5” SATA hard drive into a portable storage solution — installs into any 5.
hardware installation The MANHATTAN Hard Drive Docking Kit is designed for installation in most PC cases with an available 5.25-inch drive bay. Generalized instructions for installation are presented in this manual since the design of computer cases varies. Refer to your computer’s manual whenever in doubt about procedures. Diagrams are representational of the entire line of MANHATTAN docking kits and may not depict specific cables/connectors.
Installing the Docking Case 1. Turn off the power to your computer and any other connected peripheral devices. Follow these precautions for static electricity discharge: • Discharge any static electricity buildup in your body by touching a grounded metal surface such as the computer case, if plugged in. • During installation procedures, avoid any contact with internal device parts. 2. Unplug the power cord from the back of the computer. 3. Remove your computer’s cover. 4.
Diagrams are representational of the entire line of MANHATTAN docking kits and may not depict specific cables/connectors. SATA Connector Power Connector Mounting a Drive in the Drive Case These steps are for installing a 3.5-inch drive device in the drive case. NOTE: A special adapter kit is required in order to install a 2.5-inch drive. 1. Remove the drive case cover by sliding it toward the back of the unit. 2.
3. The drive case’s SATA cable supports 3.5-inch drives. Attach the power and SATA cables from the drive case to the drive. The power connector is “D”-shaped to help orient the connector correctly. NOTE: In order to install a 2.5-inch drive, you need a 44-pin-to-40-pin connector adapter. 4. Carefully position the drive inside the drive case 5. Secure the drive in place using the supplied mounting screws. Use the mounting holes on the sides or bottom, depending on the design of the drive. 6.
Hot-Swapping The power to your computer can be on both when the drive is inserted or removed. Use the key to turn the drive on after inserting it and off before removing it. To insert the drive case: 1. Insert the drive case (with drive installed) into the installed docking case, pushing firmly until the drive is seated. 2. Insert the provided key and lock the case in place by pushing the key in and turning it clockwise.
www.manhattan-products.com Are you completely satisfied with this product? Please contact your MANHATTAN dealer with comments or questions. ® Copyright © MANHATTAN All products mentioned are trademarks or registered trademarks of their respective owners.
