Instructions / Assembly

◆

Open the FURNITURE TIPPING RESTRAINT KIT (96) and fasten the SAFETY STRAP to the TOP (A).

Use the SHORT SCREW through the hole in the strap and into the top surface of the TOP (1).

Place your unit in its ﬁnal location.

NOTE: The following instructions show your unit being fastened to a wall stud. If you are not

fastening your unit wall stud, go to the next step now.

1st- Locate the center of a stud in your wall near your unit and mark it with a pencil.

2nd- Drill a 1/8" hole on the mark and into the stud in your wall.

3rd- Fasten the unit to the wall. Use the LONG SCREW through the other end of the SAFETY

STRAP and into the 1/8'' hole.

Page 19

WC002

Step 13

Mark and drill

a 1/8" hole into

the wall stud.