Instructions / Assembly

WALL
5
STEP 7
STEP 8
10
10
H
Attention! This step is very important!
You need to attach to the furniture on the wall to avoid any tip over risk. Follow the procedures as showed below.
Approach as close as
possible to the wall.
Pass the hardware (H) through the hole of the
part (08) as shown in the figure.
You will need a pencil to mark where you should
drill the wall with a 3/8" drill bit to put in the
hardware (E).
wings
wings
E
Press the hardware wings (E) to put in the hole that you drilled in
the wall.
Hardware (E), plugged in the wall.
E
H
K
B
K
08
Connect the hardware (H) onto the wall with hardware (B).
Then fasten with the hardware (K) the hardware (H) on the part (01).
- Insert the parts (10) as showed above.