DIGITAL DIRECTOR - Firmware Service Procedures

DIGITAL DIRECTOR – Firmware Service Procedures - rev 1.0 – 28/09/2015
Restore sequence
 Power DIGITAL DIRECTOR using fresh batteries or the AC adapter provided
 Turn DIGITAL DIRECTOR OFF using the power button (1)
 Insert the plastic pin into the reset button hole, pressing the reset button inside it (2)
 While keeping the reset button pressed, turn DIGITAL DIRECTOR ON and check
that the DIGITAL DIRECTOR LED Indicator (3) changes in the following sequence
o Lit solid green
o Lit solid red
o Lit blinking red
 At this point release the reset button and remove the plastic pin; the LED Indicator
will continue to blink for a few more seconds
 Wait until the LED Indicator turns green, initially solid and then blinking
 Turn DIGITAL DIRECTOR OFF
DISCLAIMER
The information contained in this document is subject of change without notice.
Manfrotto makes no warranty and shall not be liable for any errors on information contained in this document.
iPad is a trademark of Apple Inc.